EN User manual ZWC 1301
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Before first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 10 Washing programmes _ _ _ _ _ _ _ _ _ _ _ Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Technical data _ _ _ _ _
• Obey the maximum load volume of 3 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
• The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. Use Warning! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household environment.
Machine front Machine rear 2 1 1 2 3 4 3 4 1 Detergent dispenser drawer 2 Control panel 1 Transit locking devices 2 Drain hose 3 Door opening handle 4 Adjustable feet (front) 3 Electrical lead 4 Inlet hose Detergent dispenser drawer Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme. Compartment for liquid additives (fabric softener, starch).
Control panel 1 2 3 Spin Spin Cottons 90° 1300 Quick Drain 8h Daily Time Prewash Extra Rinse Start Pause Delay Start Eco 900 4h 60° Rinses 2h Washing Mini 30 End Eco 700 Door Wool Cold 30° Wool 40° 500 Specials Handwash 30° Delicate 40° 40° 30° Synthetics 9 8 7 6 5 4 Henceforth, the programme selector dial, the spin selector dial, programme progress lights and different buttons will be indicated in all the book with the relevant numbers given in this table.
Extra Rinse button • By means of this button, the machine performs some additional rinses. • The relevant light will light up. 8 Prewash button • By means of this button, the machine performs a prewash cycle before the main wash phase. • The relevant light will light up. 9 Time Saving button Quick Daily • By means of this button, you can select only one of the options. • The relevant light will light up.
These options can not be chosen together with the economy programmes. The washing time will be reduced depending on the type of material and the selected temperature. Recommended load for cotton is 2 kg. Before first use Warning! Ensure that the electrical and water connections comply with the installation instructions. Important! Remove any material from the drum.
Important! If you turn the programme selector dial to another programme when the machine is working, the lights in the programme progress display will start to flash to indicate a wrong selection. The machine will not perform the new selected programme. Select the spin speed, Rinse Hold or No spin option ( 2 ) Select the spin speed, Rinse Hold option or No Spin option by turning the spin speed selector. For the maximum spin speed allowed by each programme, refer to the chapter Washing programmes.
Before you make any change, you must pause the washing machine by pressing the button 6 . The programme can be changed as long as the button 6 has not been pressed. Changing a running programme is possible only by resetting it. Turn the programme selector dial to and then to the new programme position. Start the new programme by pressing the button 6 again. Interrupting a programme Press the button 6 to interrupt a programme which is running, the corresponding light starts to flash.
Before loading the laundry Never wash whites and coloureds together. Whites may lose their «whiteness» in the wash. New coloured items may run in the first wash; they should therefore be washed separately the first time. Make sure that no metal objects are left in the laundry (e.g. hair clips, safety pins, pins). Button up pillowcases, close zip fasteners, hooks and poppers. Tie any belts or long tapes. Remove persistent stains before washing.
Washing programmes Programme/ Temperature Description of the programme Type of laundry Options White and coloured cotton (heavily and normally soiled cotton items) SPIN REDUCTION/ RINSE HOLD/NO SPIN QUICK/DAILY PREWASH EXTRA RINSE DELAY START Main wash Rinses Long spin max. 1300 rpm Max load 3 kg Cotton eco This programme can be selected for normally soiled cotton items. The temperature will decrease and the washing time will be extended.
Programme/ Temperature Type of laundry Options RINSES With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The machine performs 3 rinses, followed by a final long spin. The spin speed can be reduced. SPIN REDUCTION/ RINSE HOLD/NO SPIN EXTRA RINSE DELAY START DRAIN For emptying out the water of the last rinse in programmes with the Rinse Hold option selected.
• Select the hottest cotton wash programme. • Use a normal measure of detergent, must be a powder with biological properties. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. If necessary, the whole detergent drawer can be taken out of the machine for cleaning. You need to pull it firmly outwards, so that it comes free of retaining stop.
solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the End pilot light blinks to indicate that the machine is not working: • 1 flash: problem with the water supply. Problem • 2 flashes: problem with the water draining. • 4 flashes: door open. Once the problem has been eliminated, press the button START to restart the programme.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Change it with a new one.
phoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information. Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... ... ... Technical data Dimensions Width Height Depth 50 cm 67 cm 55 cm Electrical connection Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door.
Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate programme duration (minutes) Remaining moisture (%)1) Standard 60 °C cotton 1,5 0.54 38 127 53 Standard 40 °C cotton 1,5 0.49 38 137 53 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0.10 0.98 The information given in the charts above are in compliance with the EU Commission regulation 2015/2010 implementing directive 2009/125/EC.
Return machine to it's upright position and remove the power supply cable and the draining and inlet hose from the hose holders on the rear of the appliance. Caution! Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. Water inlet Warning! This appliance must be connected to a cold water supply With a suitable spanner unscrew and remove the three screws and their spacers on machine's rear.
Water drainage The drain hose can be hooked over the edge of a sink using the plastic hose guide supplied with the machine. Make sure that the sink is empty and the plug hole is not blocked. Make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. If the machine is permanently plumbed in, hook the end of the hose into a standpipe installed for the purpose.
Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow - Earth Blue- Neutral Brown- Live 1 Green & Yellow 2 Brown 1 3 Cord clamp 4 Blue 2 4 3 The wire coloured green and yellow must be connected to the terminal marked with the letter or coloured «E» or by the earth symbol green and yellow. The wire coloured blue must be connected to the terminal «N» or coloured black.
• Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed. 22 www.zanussi.
www.zanussi.
192987442-A-332012 www.zanussi.
