REFRIGERATOR ZI 9155 ZI 9225 INSTRUCTION BOOKLET 2222748-75
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety ¥ Check the appliance for transport damage. Under no circumstance should a damaged appliance be installed. In the event of damage please contact your retailer.
Contents Instructions for the User Instructions for the Installer Important Safety Instructions . . . . . . . . . . . . . . . .2 Technical specifications . . . . . . . . . . . . . . . . . . . .11 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Before use / Setting the temperature . . . . . . . . . . .4 Fresh food refrigeration . . . . . . . . . . . . . . . . . . . . .4 Bottle holder . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 The door shelves . . . . . . . . . .
Operation Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly. Setting the temperature The temperature inside the refrigerator is regulated by a thermostat control knob with 6 temperature positions and one ÇOFFÈ (O) position. Position 1 = minimum coldness Position 6 = maximum coldness Turn the thermostat control knob to the required position.
Normal operating sounds ¥ This bottle holder shelf can be tilted in order to store previously opened bottles. To obtain this result, pull the shelf up so it can rotate upwards and be placed on the next higher level. You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing at the rear, to the cooling plate. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor.
Health and Safety Guidelines Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible. ¥ Keep the time between buying chilled food and placing it in your fridge as short as possible.
Maintenance and Cleaning Warning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Important This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Changing the light bulb Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: 1.
Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown.
Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning:08705 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.
Guarantee Conditions Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ¥ The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
Technical specifications POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY (*) ZI 9155 220-240 V / 50 Hz 100 W 0,49 kWh ZI 9225 220-240 V / 50 Hz 140 W 0,53 kWh GROSS CAPACITY 158 l 230 l NET CAPACITY 154 l 228 l (*) This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located.
Door reversal The applianceÕs door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
Electrical Connection WARNING THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home.
Building in Dimensions of the recess ZI 9155 ZI 9225 Height of housing (1) mm 880 1225 Depth of housing (2) mm 550 550 Width of housing (3) mm 560 560 50 540 3 2 D132 2. Press in the joint covers between the appliance and the kitchen furniture. 1 I PR0 50 mm min. 200 cm 2 It is necessary that the cabinet has a ventilation recess with the following dimensions: Depth 50 mm Width 540 mm 3.
8mm B A C A D PR266 PR167 5. Separate parts A, B, C, D as shown in the figure. B 8. Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ¯ 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. 50mm A 20m m PR166 6.
923631675 / 923527614 © Electrolux plc 2004
