User manual

Covering terminal board
• The recommended cross-section area is six
square millimetres (6 mm²).
• When you refit the mains terminal cover,
make sure that the lower tabs are located
inside the bottom edge of the aperture,
before you fix the two screws into the top
edge of the mains terminal cover.
• Make sure that the cover is securely
fastened.
To open the cover of terminal board
obey the procedure in opposite
sequence.
Terminal board
Do not remove blanking plates.
Make sure that the links are fitted as shown.
N N N
LL
Energy efficiency
Product information for hob according to EU 66/2014
Model identification ZCV667MNC
ZCV667MWC
ZCV667MXC
Type of hob Hob inside Freestanding Cooker
Number of cooking zones 4
Heating technology Radiant Heater
Diameter of circular cooking zones (Ø) Left front
Left rear
Right front
Right rear
18.0 cm
14.5 cm
14.5 cm
18.0 cm
Energy consumption per cooking zone (EC electric
cooking)
Left front
Left rear
Right front
Right rear
177.3 Wh/kg
180.3 Wh/kg
180.3 Wh/kg
179.4 Wh/kg
Energy consumption of the hob (EC electric hob) 179.3 Wh/kg
EN 60350-2 - Household electric cooking
appliances - Part 2: Hobs - Methods for
measuring performance.
Hob - Energy saving
You can save energy during everyday cooking if
you follow below hints.
• When you heat up water, use only the
amount you need.
• If it is possible, always put the lids on the
cookware.
• Before you activate the cooking zone put the
cookware on it.
• The cookware bottom should have the same
diameter as the cooking zone.
• Put the smaller cookware on the smaller
cooking zones.
• Put the cookware directly in the centre of the
cooking zone.
20 www.zanussi.com