User manual

Before first use
1. Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance. Do
not use detergent and do not load the baskets.
After starting a programme, it may take up to 5 minutes
for the appliance to recharge the resin in the water
softener. It seems that the appliance is not working. The
washing phase starts only after this procedure is
completed. The procedure is repeated periodically.
The salt container
Caution! Only use salt specifically
designed for dishwashers.
The salt is used to recharge the resin in the water
softener and to assure good washing results in the daily
use.
Adding salt
Before the first use, put one litre of water in the salt container.
Caution!
Water and salt can come out of the salt container during filling. To prevent corrosion, start a programme immediately
after filling the salt container.
Adding rinse aid
2
1
1
2
3
4
A
2
1
The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hot rinse
phase. Fill the rinse aid dispenser when the indicator (A) becomes clear.
Daily use
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in programme selection
mode.
• If the salt indicator is on, fill the salt container.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for the type of
load and the degree of soil.
8