User manual Ceramic glass hob EHS6646X
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Description of the appliance _ _ _ _ _ _ _ _ _ _ _ _ Operating the appliance _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 2 5 6 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 What to do if...
• Product number (Prod. Nr.) ............. .... • Serial number (Ser. Nr.) ............... You find the rating plate of the appliance on its lower casing. EHS6646X 58 HAD 47 AO 949 592 972 02 220-240 V 50-60-Hz 7,0 kW ZANKER Safety instructions Warning! You must read these! Make sure that the appliance is not damaged because of transportation. Do not connect a damaged appliance. If it is necessary, speak to the supplier. Only an authorised service technician can install, connect or repair this appliance.
Assembly 600 mm min. 500 mm min. 50 mm min. 50 mm 490+1 mm 560+1 mm R5 min. 25 mm min. 20 mm min.
Description of the appliance Cooking surface layout 1 2 145 265 mm 170 mm 145 120/210 mm mm 5 1 2 3 4 5 mm 3 Single cooking zone 1200 W Oval cooking zone 1500/2400 W Single cooking zone 1200 W Control panel Double cooking zone 750/2200 W 4 Control panel layout 1 2 3 10 4 9 5 6 7 8 Use the sensor fields to operate the appliance.
sensor field 10 function starts and stops the outer ring with an indicator Heat setting displays Displays and sounds tell which functions operate Display Description The cooking zone is off The cooking zone operates - Keep Warm setting is on The automatic heat-up function is on There is a malfunction A cooking zone is still hot (residual heat) Lock/Child safety function is on The automatic switch off is active Residual heat indicator Warning! Risk of burns from residual heat! Operating the applian
touch the same sensor field again. The next indicator comes on. Do the procedure again to switch off the outer ring. The indicator goes out. The automatic heat up function The automatic heat up function adds more power to the cooking zones and you can get a necessary heat setting in a shorter time. The automatic heat up function .A starts when you set a heat setting starting from cooking zone operates with the maximum power for some time and than automatically switches back to the heat setting you set.
• Switch off the appliance. Overriding the child safety device for one cooking session • Start the hob with . The symbol comes on. seconds. You can operate the hob. When you stop , the child safety device operates the hob with again. • Touch until the acoustic signal. The symbol comes on. Set the heat setting in less than 10 Helpful hints and tips Cookware • The bottom of the cookware must be as thick and flat as possible.
Information on acrylamides Important! According to the newest scientific knowledge, if you brown food (specially the one which contains starch), acrylamides can pose a health risk. Thus, we recommend that you cook at the lowest temperatures and do not brown food too much. Care and cleaning Clean the appliance after each use. Always use cookware with clean bottom. Warning! Sharp objects and abrasive cleaning agents will damage the appliance.
Problem Possible cause and remedy comes on. • The automatic switch-off operates. Stop the appliance and start it again. Overheating protection for the cooking zone operates. Stop the cooking zone and start it again. and a number come on. There is an error in the appliance. Disconnect the appliance from the electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect again. comes on again, speak to the after sales service.
www.electrolux.com www.zanker.
