Installation Guide

VINYL MOLDING

T-Molding (T) is 72” long and transitions dierent types of ooring of the same

height. For example, vinyl to vinyl.

Multipurpose Reducer (MPR) is 72” long and transitions ooring of dierent

heights. For example, from carpet to vinyl.

Carpet Reducer/Baby Threshold is 72” long and transitions ooring of dierent

heights. For example, from carpet to vinyl. Works with sliding glass doors and

replaces.

Overlap Stairnose is 94” long. Existing tread bullnose must be cut o.

Snap Trak (Packed with each T, MPR and SN)

• Position track 3/16” away from vinyl oor

• Screw track to suboor

• Snap molding onto track

• Track is adjustable from 3.0mm to 5.5mm thick vinyl ooring.

Base & Quarter Round is 94” and nishes the perimeter of the oor. Please take

notice the Quarter Round should be axed to the vertical surface and not

axed to the ooring itself.

Adhere a 3/8” wide piece of vinyl

oor being installed under nosing,

making it even and secure.

PAGE 1
VINYL MOLDING T-Molding (T) is 72” long and transitions different types of flooring of the same height. For example, vinyl to vinyl. Multipurpose Reducer (MPR) is 72” long and transitions flooring of different heights. For example, from carpet to vinyl. Carpet Reducer/Baby Threshold is 72” long and transitions flooring of different heights. For example, from carpet to vinyl. Works with sliding glass doors and fireplaces. Overlap Stairnose is 94” long. Existing tread bullnose must be cut off.
PAGE 2
VINYL MOLDING 100% WATERPROOF! No buckling or bowing from water spills or moisture issues. Types: 94” Stairnosing, 94” Quarter Round, 72” T-Molding and 72” Multi-purpose Reducers, 72” End Cap/Baby Threshold are available. Simple SnapTrack Installation: Same concept as Laminate flooring moldings used with Stairnosing, T-Molding, Multipurpose Reducer and End Cap/Baby Threshold.