Installation guide

※

The specifications of any product may change without prior notice to improve performance.

Thermal Pad (for FET)

Thermal Pad Outline

Water Block

Base

Thermal Pad

(for RAM)

1) Nipple Installation

①

Install the Nipple onto the Install Tap on the base side of the Water

Block.

Note

·Use a tool such as Long Nose Pliers to firmly tighten the Nipples.

·Radeon HD 3850/3870 users, please refer to the diagram shown on the

lower section of page 7 for installation details.

2) Thermal Pad Attachment

①

Clean the contact surface of the VGA Chipset completely.

② Attach each Thermal Pad to line up with the Thermal Pad Outlines indicated

on the Water Block's base as shown in the diagram below.

Note

·If the Thermal Pads are crookedly attached or attached on the wrong

place, then carefully remove them and attach properly.

·Be cautious while attaching so that the Thermal Pads do not get bent or

damaged.

·Exerting too much pressure on the Thermal Pads while attaching could

cause compression, which could lead to a gap between the Thermal

Pads and the Water Block when installed on a VGA card.

·Use of tweezers or a knife will make it easier to peel off the protective

film from the Thermal Tapes.

·Radeon HD 3850/3870 users, please refer to the diagram shown on the

upper section of page 9 for installations details.