User`s manual

3
.COM
4.InstallationRequirements
4) Cooler Orientation
3) Protective Brace Removal
Please unclip and remove the heatsink’s Plastic Brace before installing the cooler.
The Plastic Brace is in place to protect the cooler during transport.
Inrelationtothecooler’scentrallylocatedfan,airowsfromthe“thinner”(front)heatsink
tothe“thicker”(rear)heatsink.Asshowninthediagrambelow,itisrecommendedthat
thecoolerbeinstalledsothatairowsfromthecoolertowardtheenclosure’srear
exhaust fan to be released.
96㎜
154㎜
133㎜
PSU
VGA slot
Front SideRear Side
Enclosure’s (Rear) Exhaust
1)SpaceRequirements
2) Air Guide Removal
Thecooler’sinstallationrequiresunobstructedspacewithdimensionsof
133mm(width), 154mm(length), 96mm(height), and the CPU as a central
reference point. Please check if components such as ODDs and PSU protrude
intotherequiredspace.
Air guides on enclosures must be removed, before the cooler’s installation, for
theyprotrudeintothecooler’srequiredspace.