User`s manual

◆ When the Speed Control Knob on Fan Mate 2 is turned counter-clockwise, fan speed is

lowered. Turned clockwise, it is increased. Thus, you can select the desired fan speed by

turning the knob.

Please adjust the fan speed to a desired setting. For CPU temperature specifications,

please inquire to the CPU manufacturer.

Note) Fan Mate 2 has been specifically designed for the fan of this product.

ZalmanTech Co., Ltd. is not responsible for any damages to the system or CPU

resulting from its use with other types of fans.

ZalmanTech Co., Ltd. is not responsible for any damages resulting from CPU

Overclocking.

The computer system may automatically shut down when booting the computer after the

system monitoring program outputs a warning stating that the CPU fan is rotating slowly.

In such a case, fully turn the Speed Control Knob in the clockwise direction before

rebooting to disable the 'CPU Fan Detected' option in BIOS, or set the CPU fan's

rotational speed to 1,350rpm or lower in the system monitoring program.

Note) Some motherboards fail to boot if the rotational speed of the CPU fan is below a

certain rpm. However, booting can be possible even at low fan rpm if the BIOS

settings are updated. For more information on updating the BIOS, please refer to the

website of the motherboard's manufacturer. There are motherboards which fail to

detect the rpm while operating the cooler in Silent Mode, but this does not affect

computing performance.

Pull the 6-Pin Connector

(⑬)

out of the

system through the back and connect it to

Fan Mate 2

(⑪)

, which should be installed

on the case using the included Double-

Sided Tape

(⑩)

Connect the two 3-pin connectors of the cable to

the motherboard and to the CNPS7000C’s Fan

Connector as shown in the diagram.

1) Fan Mate 2 Installation on the Inside of a System

2) Fan Mate 2 Installation on the Outside of a System

1) Caution During Booting

2) Overclocking