Specifications

The specifications of any product may change without prior notice to improve performance.
6
Nipple Installation
Place a small washer on the motherboard. Then, put a nipple over it and fasten the nipple until the
Backplate for AMD64 is firmly attached to the motherboard on the opposite side of the CPU.
* A Retention Guide is not necessary for installing CNPS7700 LED on Socket 754/939/940.
Installation of Grips and Bolts
Interlock the L-Type grips with the clip. Insert the two bolts
into the outer holes of the grips.
FHS Placement
Set the FHS at the center of the CPU. Screw the bolts
in slightly, and then tighten each bolt a few turns at a
time while alternating between the two until the Grips
are completely pressed against the Nipples.
Connect Power (Use FAN MATE 2)
Please refer to FAN MATE 2 Installation and Usage on page 7.
Thermal Grease Application
Clear off particles and residue from the top of the
CPU then spread a thin layer of the included thermal
grease thoroughly on top of the CPU.
Bolt
Grip (L-Type)
Outer Hole
Grip (L-Type)
Nipple
3) AMD Sempron/AMD64 - Socket 754/939/940
CPU (Lid)
Thermal Grease
Backplate for AMD64
Nipple
Motherboard
Small Washer