User's Guide

Lift open Machine Cover to

expose Carriage and Blade

Holder Clamp.

Loosen Clamp by turning

Clamp Screw counterclockwise,

approximately 1/4 of a

turn. IMPORTANT: Spring

on end of Clamp Screw

MUST be kept in place.

Place Blade Holder into Clamp,

making sure that Depth Selection

Arrow is facing out.

1 2 3

Clamp Screw

Top Edge of Clamp

Depth Selection

Arrow

White Ring

Angled

Cutting Edge

Safety Cap

Insert this end

into Blade Holder

Non-Cutting Side

Tighten Blade Holder by turning

the Clamp Screw clockwise, until

Blade Holder is secure.

Clamp Screw

Clamp

SET UP

CAUTION: CUTTING HAZARD Blade is sharp, handle with care.

WARNING: MOVING PARTS Keep fingers, hair and clothing away.

CAUTION: CUTTING HAZARD Keep fingers away from exposed blade.

CAUTION: Always unplug Machine before removing or installing Blade Holder.

INSTALLING THE CUTTING BLADE HOLDER

Carefully remove Safety Cap from

Blade, exposing Angled Cutting

Edge.

Carefully insert Non-Cutting Side

of Blade into hole at bottom of

Blade Holder. Blade is held in

place magnetically.

Note that Blade is exposed, but

barely visible, when inserted

properly.

1 2 3

INSERTING THE BLADE INTO THE BLADE HOLDER