User Manual

INSTRUCTIONS

ENFORCER

YOUR CAMERA

HERE

TO UNFOLD GUNSTOCK PUSH DOWN ON SILVER BOLT WITH YOUR THUMB

WHILE PULLING UP ON THE BOTTOM OF THE GUNSTOCK ARM.

WITH THE GUNSTOCK ARM

LIFTED, ROTATE THE ARM

180º INTO THE OPEN

POSITION AS SHOWN.

NEXT PRESS THE LEVER AS SHOWN AND RAISE THE CAMERA SUPPORT

ARM INTO POSITION.

WITH YOUR CAMERA ATTACHED TO THE

GORILLA PLATE, ENGAGE 15MM ROD

STUD INTO THE BOTTOM OF THE

BASEPLATE AND SECURE BY TURNING

THE RED LEVER.

FIRST POSITION:

for use with cameras

equipped with a z-ﬁnder.

SECOND POSITION:

for use without a z-ﬁnder.

NOTE: Gunstock:

The gunstock can be pivoted so that it makes optimal contact

with the shooter’s chest or shoulder. Loosen the 2 screws to

pivot the pad to the correct angle.

In some instances, depending on the type of camera used or the

size of the shooter, the gunstock pad will need to be ﬂipped into

the down position for optimal comfort. To do this, unscrew the 2

10-32 allen screws completely, ﬂip the gunstock 180 and reat-

tach the screws.

check out our tutorial videos

at zacuto.com

NEED

HELP?

5/32” allan

PULL UP TO

RE-POSITION

LEFT LOOSE

RIGHT TIGHT

NOTE:

PRESS

DOWN

PULL UP

PRESS