User`s manual

BL160020 s Getting Started
P1
J1
Latch
D2
P2
H1
U5
PAL
PAL
U6
U4
SCC2691 UART
U1
3.686
MHz
U2
RN1
D1R2R1
C1 C3 C4 C2
H2
RS-232 Driver
RS-232
Jack
XP8700
BL1600
H5
H4
U1 U2
U6
U11
J4
H1
Battery
serial cable
to PC
H1
Option 2XP8700 expansion board.
Use the programming cable to connect the PCs 9-pin or 25-pin RS-232
serial port to header H1 on the XP8700. Either PC serial port (COM1
or COM2) may be used. (If you are using a non-Z-World programming
cable with an RJ-12 plug instead of a 10-pin connector, connect the
RJ-12 plug to the RJ-12 jack on the XP8700.) Connect the XP8700 to
the BL1600s PLCBus port as shown in Figure 2-4.
Figure 2-4. Use of XP8700 to Program BL1600
4. The BL1600 is now ready for programming. The power supply may be
plugged in and turned on.