User`s manual

BL160018 s Getting Started
Initial BL1600 Setup
Parts Required
 24 V unregulated DC power supply
 Programming cable
 Optional XP8700 expansion board (needed if the RS-232 port on the
BL1600 is required by the application).
The necessary parts are supplied with the Developers Kit.
Connecting the BL1600 to a Host PC
1. Connect the power supply to the BL1600. Connect the two leads from
the DC power supply or wall transformer to header J2 as shown in
Figure 2-1. Do not power up the power supply until the remaining
steps have been completed.
Figure 2-1. Bl1600 Power Supply Connections at Header J2
Be careful to connect the power supply wires to the correct
sockets on header H2. The BL1600 may be destroyed in an
instant if the power supply is connected to the wrong socket.
A protective diode prevents damage to the BL1600 if the
power supply polarity is reversed.
DCIN
J2
K
HC7
HC6
HC5
HC4
HC3
HC2
HC1
RS485+
RS485
GND
to wall
transformer