User`s manual

XP8000 Series (PLCBus
TM
) Z-World 530-757-3737 22
Jumpers
There are 4 locations for jumper blocks. Not all of the jumper
blocks may be installed on your particular model.
XP8100 Jumpers (16 Inputs, 16 Outputs)
J1 Bank A outputs 0–15, sinking vs. sourcing configuration
J2 Bank B inputs 0–7, pull-up/down resistors
J4 Bank B inputs 8–15, pull-up/down resistors and board address
XP8110 Jumpers (32 Inputs)
J2 Bank A inputs 0–7 and bank B inputs 0–7, pull-up/down resistors
J4 Bank A inputs 8–15, bank B inputs 8–15, pull-up/down resistors,
and board address
XP8120 Jumpers (32 Outputs)
J1 Bank A outputs 0–15, sinking vs. sourcing configuration
J3 Bank B outputs 0–15, sinking vs. sourcing configuration
J4 Board address
TTL- and CMOS-Compatible Outputs
If you want TTL- or CMOS-compatible outputs, Z-World will
install the appropriate connections required. You have to re-
quest it. With TTL/CMOS outputs, input and output channels
may be configured independently in any combination.
Specifications
Inputs
Input voltage range –20V to +24V continuous. Protected againsts
spikes in ±
48V range.
Logic threshold
2.5V
Resistors User-settable, pull up or pull down, in groups
of four and eight
Input protection low-pass filter,
22K current-limiting series re-
sistor, input-protection diode
Low-pass filter
220 µs
Input-leakage current
5 mA
Outputs
Default Sinking drivers (2803)
Maximum current
500 mA single channel
Non-inductive voltage +
5V to +48V
Inductive voltage +5V to +30V
Switching response 1 µs
Leakage current
100 mA max
The UDN2985 is rated at 30V and 250 mA for an individual out-
put at 25°C.
FWT50
Total I/O Channels 16
Pitch 5 mm
Maximum Wire
24–12 AWG
Quick Disconnect No
Wire Orientation Side
FWT38
Total I/O Channels 16
Pitch 3.81 mm (0.15")
Maximum Wire
28–16 AWG
Quick Disconnect Yes
Wire Orientation Top
FWT-Opto
Total I/O Channels 16, optically isolated (input channels only)
Pitch
3.81 mm (0.15")
Maximum Wire
28–16 AWG
Quick Disconnect Yes
Wire Orientation Top
Input Protection
5 kV RMS between input and output
AC Input Response –40V to +40V
//
2.85
0.25 typ
0.125
0.925
~0.425
~0.32
~0.81
0.115 dia, 2x
2.85
0.25 typ
0.125 typ
0.925
~0.7
~0.32
~1.1
0.115 dia, 2x
H1 U1
U2
H2
3.275
4.20
0.925
0.35, 2x
~0.7
~0.32
~ 1.1
0.115 dia, 2x
1.1 5
U1
U2
U4U5
U6
H1 H2
U3
FWT-50
FWT-38
FWT-OPTO