User`s manual

PK2100I-8 s Index
programming
Full C .................................... 4-3
gate ......................4-2, 4-3, 5-12
programs
downloading ......................... 4-2
uploading .............................. 4-2
protective diodes..................... 3-12
PRT ........................................... 3-7
Timer Channel 0 .................. D-8
PRT0DEMO.C .......................... 5-12
pulse measurement ................... 3-8
pulse width measurement ......... 3-3
R
RAM
battery-backed .....1-3, 1-4, 2-2,
C-3
raw values .................. 5-4, 5-5, 5-6
read-only memory ........... 1-3, 1-4,
2-2, 3-9, 5-3, 5-10
read12data ............................ F-7
read24data ............................ F-8
read4data ............................... F-7
read8data ............................... F-8
reading data on the PLCBus ...........
F-3, F-4
READIO.C ............................... 5-12
READKEY.C ............................. 5-12
real-time
clock .....................1-3, 4-3, 5-8
kernel ....................4-3, 4-4, 5-8
recalibration
EEPROM .............................. E-4
receive buffer .......................... 5-11
receiver interrupt .................... 4-10
regulated input voltage .............C-2
RELAY1, RELAY2 .......... 4-6, 5-2
relays......................................... 3-4
built-in ......................... 1-2, 3-12
contacts ............................... 3-11
DIP ........................................ F-2
drivers ................................... F-6
external ................................. 1-2
output ........... 3-4, 3-10, 4-6, 5-2
reset
system .......................... C-2, C-3
resistance bridge ....................... 3-4
resistor
excitation .............................. 3-5
load ....................................... 5-3
restore
LCD screen ........................... 4-5
ROM ......................................... 1-3
flash .................................... 5-10
programmable ......1-3, 1-4, 2-2,
............................3-9, 5-3, 5-10
RR ............................................. 3-5
RS-232
communication ......1-2, 2-2, 2-3,
3-2, 3-4, 4-2, 4-8, 5-11
expansion card .................... 5-11
serial output . 3-2, 3-4, 4-2, 5-11
serial port .................... 3-4, 3-14
RS-485
communication ............. 1-2, 3-4
serial output .......................... 3-4
serial port .................... 3-4, 3-14
RS232.C ................................. 5-14
RS485.C ................................. 5-14
RTK .......................................... 4-4
RTS ........................................... 4-9
RUNKERNEL ............................... 4-4
RX- ........................................... 3-2
RX+ .......................................... 3-2
S
sample programs................ 5-2, 5-7
gate programming................. 4-2
virtual driver ......................... 4-4
VWDOG.C ............................... 4-4
save
LCD screen ........................... 4-5
SCAN.C ............................ 4-2, 5-12
SCANBLK.C ............................. 5-12
screw connectors .............. 3-2, B-7
screw terminals ................. 3-2, B-7
Serial Channel 0
block diagram ....................... 4-9