User`s manual

PK2200 Getting Started s 19
Figure 2-2 illustrates the power supply connections.
Figure 2-2. Power Supply Connection
4. Plug the power supply into a wall socket.
The PK2200 is now ready to run.
Establishing Communication with the PK2200
To establish communication with the PK2200 use the following steps.
1. Double-click the Dynamic C icon to start the software. Note that each
time you start Dynamic C, communication with the attached PK2200 is
attempted.
2. If the communication attempt is successful, no error messages are
displayed.
If an error message such as Target Not Responding or
Communication Error is displayed, see Appendix A,
Troubleshooting.
After making necessary changes to establish communication
between a PC and the PK2200, use the Dynamic C shortcut
<Ctrl-Y> to reset the controller and initialize communication.
+DC
K
GND
Red Shrink Wrap
Power
Supply
Leads
-
+
Long Lead
Short Lead
J1
!
$