User`s manual

PK220016 s Overview
CE Compliance
The PK2200 has been tested by an approved competent body,
and was found to be in conformity with applicable EN and
equivalent standards. Note the following requirements for
incorporating the PK2200 in your application to comply with
CE requirements.
 The power supply provided with the Development Kit is for develop-
ment purposes only. It is the customers responsibility to provide a
clean DC supply to the controller for all applications in end-products.
 Fast transients/burst tests were not performed on this controller. Signal
and process control lines longer than 3 m should be routed in a separate
shielded conduit.
 The PK2200, PK2210, PK2220, and PK2230 were tested to Industrial
Immunity Standards. The PK2240 has been tested to Light Industrial
Immunity standards. Additional shielding or filtering may be required
for the PK2240 for an industrial environment.
 The PK2200 has been tested to EN55022 Class A emission standards.
Additional shielding or filtering will be required to meet Class B
emission standards.
Visit the Technical Reference pages of the Z-World Web site
at http://www.zworld.com for more information on shielding
and filtering.
$