User`s manual

XP8600/XP890092 s Simulated PLCBus Connections
(
BL1400 and BL1500
Expansion boards may be connected to header H3 on the BL1400 and
BL1500. The signals, listed in Table D-1, are laid out differently from
those on the other controllers, and so the special cable used for the
BL1000, the BL1100, or the BL1300 controllers will not work. The user
may either make a custom cable or use an adapter board available from
Z-World. Software from the Dynamic C EZIOMGPL.LIB library may be
used.
Use an external power supply with expansion boards con-
nected to the BL1400 or BL1500. There is no provision to
supply power from the controller to header P1 or P2 on the
expansion boards. The adapter board has a jack and a screw
terminal for the external +12 V/+24 V.
For more information on the adapter board, call your Z-World
Sales Representative at [phone].
Table D-1. PIO Header to PLCBus Signal Map
BL1400/BL1500 Expansion Board
Header H3 Pin PIO Port Signal Header P1/P2 Pin PLCBus Signal
1+5 V 2 +5 V
2PA0 5/STBX
3PA119D0X
4PA220D1X
5PA317D2X
6PA418D3X
7 PA5 11 A1X
8PA6 9 A2X
9PA7 7 A3X
10 GND 10 GND
!