User`s manual

XP860034 s Software Reference
Sample Program
The sample program demonstrates how to drive the XP8600 in a voltage-
output mode. The program runs on controllers with a PLCBus.
Materials Required
1 kΩ, ¼ W resistor and an LED
OR
 digital volt-ohm meter
Instructions
1. Power up the controller and make sure it is working properly. Consult
the controller users manual, if necessary. Now disconnect power from
the controller.
2. Connect the XP8600 to the controller. See Chapter 2, Getting
Started, for more details.
3. Check headers J1 through J3. Leave J3 unjumpered. Connect pins 23
on headers J1 and J2 (for voltage output).
4. Wire-wrap or solder together the resistor and the LED, as shown below,
to make a load circuit 3" to 4" (7 cm to 10 cm) long.
5. Connect the resistor end of the load circuit to V/I1 on header H1.
Connect the LED to GND on H1. Figure 4-1 shows the pins on Wago
connector H1. Alternatively, the volt-ohm meter may be connected
between V/I1 and GND.
Figure 4-1. XP8600 Wago Connector H1
H1
VI2
GND
VI1
GND
VCC
V
V+
1
2
3
45
6
7
8
+24 V