User`s manual

XP8600

22 s I/O Configurations

XP8600 Pin Assignments

Analog signals (voltage or current output) leave the XP8600 via terminals

1 and 3 on Wago connector H1. Terminals 2 and 4 provide ground. Other

terminals provide access to board voltages.

When the XP8600 is used with a BL1200, BL1600, BL1700, PK2100, or

PK2200 controller, the +24 V from the PLCBus serves as the power

source, and is accessible on pin 8 of Wago connector H1. When the

XP8600 is used with BL1000, BL1100, BL1300, BL1400, or BL1500

controllers, the +24 V is not available and must be supplied from an

external source to pin 8 on H1 or to the BL1400/BL1500 adapter board.

Figure 3-1 shows the pin assignments for Wago connector H1.

Figure 3-1. XP8600 Wago Connector H1

Voltage or Current Output

The XP8600 uses two jumper blocks, J1 and J2, to set the mode of output

channel 1 (VI1 on H1) and output channel 2 (VI2 on H1), respectively.

Connect pins 23 to select a voltage output for the channel corresponding

to the jumper block, and connect pins 12 to select a current output.

Figure 3-2 summarizes the jumper settings.

Figure 3-2. XP8600 Output Channel Jumper Settings

Voltage Output

Current Output

Output Channel 1

Output Channel 2

VI2

GND

VI1

GND

VCC

V

V+

+24 V