Instructions

16
FCC Statement (FCC - Federal Communications Commission)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Do not make any changes or
modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, it may be
necessary to stop operation of the equipment.
Note:
If static electricity or electromagnetism causes data transfer to discontinue midway (fail), restart the application or disconnect and connect the
communication cable (USB, etc.) again.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Co-location warning:
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
OEM integration instructions:
This module has a LIMITED MODULAR APPROVAL, and is intended only for OEM integrators under the following conditions: As single, non-
colocated transmitter, this module has no restrictions in relation to a safe distance from any user. The module shall be only used with the
antenna(s) that have been originally tested and certified with this module.
As long as these conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for
testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions,
PC peripheral requirements, etc.).
Validity of using the module certification:
In the event that these conditions cannot be met, or when installing this module in another host as tested in this FCC filing, then the FCC
authorization for this module in combination with the host equipment is no longer considered valid and the FCC ID of the module cannot be
used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
Custom design antennas may be used, however the OEM installer must following the FCC 15.21 requirements and verify if new FCC approval
will be necessary.
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user's
manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as
show in this manual.
All questions regarding this declaration of conformity can be directed to the following address:
Z-Wave.Me
c/o Alsanet S.A.
10 ch. Champ-Claude
1214 Vernier
Switzerland
FCC Device ID: 2AAYU- ZMEURAZ