Instructions

10
Expert Commands
The expert command section displays the status values and possible commands in a very generic way. On the left hand
side the different channels of the device are listed in a column. In case there is only one channel (that’s the case for most
devices) only channel 0 is shown. Clicking on the number opens a dialog showing all internal variables for the channel. The
next column shows all the command classes exposed by the device. Again clicking on the name opens a dialog with more
internal status variable information for this command class.
On the right hand side there is a list of commands. This UI is auto-generated from the information provided by the
command class itself and not optimized for daily usage.
Firmware Update
In case the device supports a firmware update ‘over the air’ this dialog is shown to perform such a firmware update. The
firmware can be provided in two ways: either as URL in the format http://IP:PORT/file or as file upload using the file upload
dialog. The firmware file must be available in raw ‘BIN’ format or ‘HEX’ format. The target field allows specifying the target
memory/processor for the update process. For updating the Z-Wave firmware part a ‘0’ must be set. The firmware
updating process will take up to 10 minutes. Please don’t do any other operation during this time.
It may be required to activate the firmware update mode on the device to be updated. Please refer to the manual for
further information about activation.