User manual

8
CONFIGURATIONS
Required Tools
• Philips Screwdriver
Doc# 27-0044UM Rev B Issued 7/13/2012
3.0 CONFIGURING YOUR ZX3 STATION
This section will provide information and assistance with the following topics:
• Updating ZX3 modules and configurations
• Removing/Re-installing Lockable Face Plate Cover
• Removing/Re-installing ZX3 Top Cover
• Changing/Re-installing a PCI card
• Removing/Re-installing a Power Supply Module
Preparations
In preparation to any congurations change
to the ZX3, turn off the electrical power to
the ZX3 serve and your computer.
3.1 REMOVING TOP COVER OF ZX3 STATION
3.2 REMOVING/INSTALLING MEMORY DIMM
1. Loosen both lock screws at the rear of
the unit.
4. Pull the top back to clear the side
tongues from the grooves in the casing
and lift the top away.
2. Using one hand, push slightly down
on the front edge of the top and use
the other hand to pull the top from the
rear or the unit.
3. When the top is disengaged from the
locked position, use your thumbs to apply
leverage while your fingers start to pull
the top towards you.
5. Once you have cleared the side tongues
from the grooves, lift the lid from the
ZX3 station.
1. Each of the Memory DIMM slots
is equipped with locking latches to
secure the Memory DIMM in place.
3. The existing Memory DIMM will pop out of
the slot. Gently remove the Memory DIMM
from the slot.
2. Use your fingers to push the locking
latches away from the existing Memory
DIMM.
(CONTINUED)...
Contents
Setup
Operations
Troubleshooting
Appendix
Support
Congurations
Maintenance