User manual
15
WARNING
WARNING
Be sure to turn off the power before
you perform any maintenance on
the server.
It is recommended that users do not
service the server. User maintenance
is restricted to removal and installation
of modules and COTS parts, and to
cleaning as explained below.
CAUTION: Do not use benzene, thinner,
ammonia or any volatile substance to clean
the server housing. These chemicals may
damage the unit.
Doc# 27-0044UM Rev B Issued 7/13/2012
MAINTENANCE
5.0 MAINTENANCE
5.1 CLEANING THE ZX3 SERVER
Unplug the ZX3 server from the power outlet before cleaning.
• To clean the surface of the ZX3, lightly dampen a soft, clean cloth with water or mild detergent and
wipe the surface gently.
5.2 REPLACING THE ZX3 AIR FILTER
This section will provide information and assistance with the following topics:
• Cleaning the ZX3 Server
• Replacing the ZX3 Air Filter
1. Remove the ZX3 station face plate by
twisting the screws on the left side of
the unit. Repeat the procedure on the
right side.
2. Remove the casing front cover from the
ZX3 station.
3. Remove the existing air lter strip from
the unit and discard..
4. Install the new lter to the unit and use
your ngers to press it rmly into place.
5.Reattach the face plate and tighten the
screws on both sides
Contents
Setup
Operations
Troubleshooting
Appendix
Support
Congurations
Maintenance