User manual

14
Doc# 27-0044UM Rev B Issued 7/13/2012
OPERATIONS
4.4 INSERTING THE TRANZPAK2 STORAGE MODULE
4.3 REMOVING THE TRANZPAK2 STORAGE MODULE
1. Slide the locking catch towards the right
to allow the locking handle to spring open.
3. Push the locking handle to the left.
This will disconnect the TranzPak2 from
the rear connector.
4. Gently but firmly begin to pull the
TranzPak2 module out as it slides off the
grounding contacts.
2. The locking handle will swing out.
1. Raise the TranzPak2 module to the slot.
and insert into the docking bay .
2. Use your thumb to gently push on the
TranzPak2 thumb plate in order to slide
the module into the docking bay
3. Gently push on the TranzPak2 thumb
plate until the module is seated against
the rear connector.
4. Press the locking handle until it snaps
into place.
Contents
Setup
Operations
Troubleshooting
Appendix
Support
Congurations
Maintenance