Service manual

9-6 Sun Ultra 2 Series Service Manual • July 1996
b. Connect the following if present:
■ SCSI cable to the CD-ROM drive or 4-mm or 8-mm tape drive.
■ Diskette cable to the diskette drive.
■ Peripheral power cable to the CD-ROM drive or 4-mm or 8-mm tape drive (P3)
and the diskette drive (P2).
c. Position the chassis bracket into the chassis.
d. Slide the chassis bracket toward the chassis side opening.
Note – Chassis base hooks must lock into the chassis bracket bottom holes.
e. Connect the DC harness to the peripheral power cable at P1.
f. Replace the following:
■ DC harness to the clip located on the chassis bracket.
■ Screws securing the chassis bracket to the chassis.
2. Close the shroud assembly.
3. Detach the wrist strap.
4. Replace the system unit cover.
See Section 7.3 “Replacing the System Unit Cover” on page 7-4.
5. Power on the system unit.
See Section 6.1 “Powering On the System Unit” on page 6-1.
9.3 CD-ROM Drive or 4-mm/8-mm
Tape Drive
To remove and replace the CD-ROM drive or 4-mm/8-mm tape drive, proceed as
follows.