Service manual

9-2 Sun Ultra 2 Series Service Manual • July 1996
4. Remove the EMI door.
5. Remove a hard drive as follows (
FIGURE 9-1):
a. Open the hard drive handle.
b. Extend the disk drive handle straight out (90 degrees) from the disk drive to
disconnect the disk drive from the system.
Caution – Do not extend the hard drive handle more than 90 degrees from the
locked position. Do not use it as a lever against the system unit chassis to pry the
hard drive from the drive bay. Doing either can break the lever or the hard drive
mount.
c. Pull on the hard drive handle to remove the hard drive straight out from the
drive bay.
6. Place the hard drive on an antistatic surface.
Note – Ensure that the hard drive is placed on the antistatic mat with the printed
circuit card side up.
FIGURE 9-1 Removing and Replacing a Hard Drive
Hard drive handle
EMI door
Hard drive
Drive bay slot (2)
(approximately 90 degrees)