Service manual

9-1

CHAPTER

Storage Devices

This chapter describes how to remove and replace the Ultra 2 series storage devices.

This chapter contains the following topics:

■ Section 9.1 “Hard Drive” on page 9-1

■ Section 9.2 “Media Bay Chassis Bracket” on page 9-4

■ Section 9.3 “CD-ROM Drive or 4-mm/8-mm Tape Drive” on page 9-6

■ Section 9.4 “Diskette Drive” on page 9-9

9.1 Hard Drive

To remove and replace a hard drive, proceed as follows.

9.1.1 Removing a Hard Drive

1. Power off the system unit.

See Section 6.2 “Powering Off the System Unit” on page 6-2.

2. Remove the system unit cover.

See Section 7.1 “Removing the System Unit Cover” on page 7-1.

Caution – Use proper ESD grounding techniques when handling components. Wear

an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive

components in antistatic bags before placing it on any surface.

3. Attach the wrist strap.

See Section 7.2 “Attaching the Wrist Strap” on page 7-3.