Service manual

Chapter 8 Major Subassemblies 8-11
FIGURE 8-5 Shroud Assembly Removal
8.3.2 Replacing the Shroud Assembly
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Replace the shroud assembly as follows (
FIGURE 8-5):
a. Position the shroud assembly face down.
b. Position the motherboard on the shroud assembly, ensuring that the shroud
assembly retaining clips are aligned with the motherboard retaining clip holes.
c. Secure each retaining clip by pressing down on the motherboard around the
area of each retaining clip.
d. Slowly turn over the motherboard, ensuring that the shroud assembly and the
motherboard connection is secure.
2. Replace the motherboard.
See Section 10.6.2 “Replacing a Motherboard” on page 10-24.
Motherboard
(bottom view)
Retaining clip (5)