Service manual

Chapter 8 Major Subassemblies 8-9
FIGURE 8-4 Removing and Replacing the Diskette Drive Cable Assembly
8.2.4 Replacing the Diskette Drive Cable Assembly
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Replace the diskette drive cable assembly as follows (
FIGURE 8-4):
a. Position the diskette drive cable.
b. Connect the following:
■ P1 connector to J1201 on the motherboard.
Diskette drive
cable assembly
P2
P1
J1201