Service manual

8-6 Sun Ultra 2 Series Service Manual • July 1996
2. Remove the system unit cover.
See Section 7.1 “Removing the System Unit Cover” on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 “Attaching the Wrist Strap” on page 7-3.
4. Disconnect the following (
FIGURE 8-3):
a. P2 connector from the CD-ROM drive (or 4-mm/8-mm tape drive).
b. P1 connector from J1202 on the motherboard.
c. P3 connector from J1203 on the motherboard.
5. Remove the SCSI cable assembly.