Service manual

8-4 Sun Ultra 2 Series Service Manual • July 1996
2. Push the power supply toward the chassis rear, engaging the mounting hooks.
Note – Ensure that the hooks located on the chassis base engage with the cutouts
located on the bottom of the power supply.
3. Using a number 2 Phillips screwdriver, tighten the captive screws securing the
power supply to the back panel.
4. Connect the following power supply connectors to the motherboard (
FIGURE 8-2:
■ J4 to J3204
■ J3 to J3203
■ J2 to J3205
■ J1 to J3206
5. Connect the J6 power supply connector to the diskette drive.
6. Connect the J5 power supply connector to the CD-ROM drive (or 4-mm/8-mm tape
drive).
7. Connect the AC power cord.
8. Detach the wrist strap.
9. Replace the system unit cover.
See Section 7.3 “Replacing the System Unit Cover” on page 7-4.
10. Power on the system unit.
See Section 6.1 “Powering On the System Unit” on page 6-1.