Service manual

Chapter 8 Major Subassemblies 8-3

FIGURE 8-1 Removing the Power Supply

8.1.2 Replacing the Power Supply

Caution – Use proper ESD grounding techniques when handling components. Wear

an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive

components in antistatic bags before placing it on any surface.

Caution – The AC power cord must be disconnected while the power supply is

being removed and replaced. Do not reconnect the power cord while the power

supply is outside of the chassis.

1. Position the power supply into the chassis.

Power supply

Chassis rear

Captive screw (2)

J5/J6