Service manual

4-14 Sun Ultra 2 Series Service Manual • July 1996
4.6.5 Test alias name, device path, -All Diagnostic
The test diagnostic, when combined with a device alias or device path, enables a
device self-test diagnostic program. If a device has no self-test program, the
message: No selftest method for device name is displayed. To enable the
self-test program for a device, type the test command followed by the device alias
or device path name.
The following code example identifies the test diagnostic output message.
TABLE 4-10
lists the test diagnostics that can be initialized by typing the test (alias name, device
path, -all) command at the ok prompt, a description of the selection, and preparation.
Note – The diskette drive (floppy) is selected as the test alias name example.
Target 0
Unit 0 Disk QUANTUM VK2275J SUN2.1G1210
Target 1
Unit 0 Disk SEAGATE ST32171W SUN2.1G8254
Target 6
Unit 0 Removable Read Only device TOSHIBA XM5701TASUN12XCD0997
{0} ok
CODE EXAMPLE 4-6 Test Diagnostic Output Message
{0} ok test floppy
Testing floppy disk system. A formatted disk should be in the
drive.
Test succeeded.
{0} ok
CODE EXAMPLE 4-5 Probe-SCSI-All Diagnostic Output Message (Continued)