Service manual

3-10 Sun Ultra 2 Series Service Manual • July 1996
0> Mapping Selftest Enabling MMUs
0> Clear Interrupt Map and State Registers
0> SysIO Interrupts Test
0> SysIO Timers/Counters Test
0> IOMMU Virtual Address TLB Tag Compare Test
0> Streaming Buffer Flush Test
0> DMA Merge Buffer Test
0>CPU Speed
0> CPU 0 Running at 200 MHZ.
0>Ecache Stress Test
0> Ecache Stress Test
0>APC Test
0> APC Registers Tests Test
0> APC DVMA Test
0>Data Cache Test
0> Dcache Init
0> Dcache Enable Test
0> Dcache Functionality Test
0>FEPS Test
0> Parallel Port Registers Test
0> Parallel Port ID is: 0x2
0> Parallel Port DVMA burst mode read/write Test
0> FAS366 Registers Test
0> ESP FAS366 DVMA burst mode read/write Test
0> FEPS Internal Loopbacks Test
0> Ethernet Tranceiver Internal Loopbacks Test
0>CPU Functional Test
1>CPU Functional Test
0> Mapping Selftest Enabling MMUs
1> Mapping Selftest Enabling MMUs
0> SPARC Atomic Instructions Test
1> SPARC Atomic Instructions Test
0> CPU Dispatch Control Register Test
1> CPU Dispatch Control Register Test
0> CPU Softint Registers and Interrupts Test
1> CPU Softint Registers and Interrupts Test
0> CPU Tick and Tick Compare Registers Test
1> CPU Tick and Tick Compare Registers Test
0> Uni-Processor Cache Coherence Test
0> Base_address = 00100000
1> Uni-Processor Cache Coherence Test
1> Base_address = 00300000
0> UltraSPARC-2 Prefetch Instructions Test
1> UltraSPARC-2 Prefetch Instructions Test
0> *UltraSparc-1 module detected, tests skipped
1> *UltraSparc-1 module detected, tests skipped
CODE EXAMPLE 3-1 diag-level Variable Set to max (Continued)