Service manual

Index-5
pre-POST preparation, 3-2
setting up tip connection, 3-2
verifying baud rate, 3-4
PrestoServe 2.4.2, C-4
printer connectivity, C-20
probe
SCSI diagnostic, 4-13
SCSI-all diagnostic, 4-13
probe-scsi-all diagnostic output message, 4-13
procedures, troubleshooting, 4-1
processor
UltraSPARC I, C-4
UltraSPARC II, C-4
product
description, 1-1
specifications, A-1
progress reporting, POST, 3-12
R
RAMDAC, C-25
rear view
system unit, 6-2
removing
4-mm tape drive, 9-7
8-mm tape drive, 9-7
CD-ROM drive, 9-7
chassis bracket, 9-4
CPU module, 10-1, 10-3
diskette drive, 9-9
diskette drive cable, 8-8
DSIMM, 10-17
hard drive, 9-1
motherboard, 10-21, 10-23
NVRAM/TOD, 10-4
power supply, 8-1, 8-3
SBus card, 10-6, 10-7
extractor, 10-10
SBus card adapter, 10-9
SCSI cable, 8-5
shroud assembly, 8-10, 8-11
speaker, 8-12, 8-13
system unit cover, 7-1, 7-2
UPA graphics card, 10-11, 10-13
replaceable components, system unit, 1-5
replacement
component, 10-1
motherboard, 10-1
replacing
4-mm tape drive, 9-8
8-mm tape drive, 9-8
CD-ROM drive, 9-8
chassis bracket, 9-5
CPU module, 10-3
diskette drive, 9-11
diskette drive cable, 8-9
DSIMM, 10-18
hard drive, 9-3
motherboard, 10-24
NVRAM/TOD, 10-5
power supply, 8-3, 8-5
SBus card, 10-8, 10-11
SCSI cable, 8-7
shroud assembly, 8-11
speaker, 8-13
system unit cover, 7-4
UPA graphics card, 10-13, 10-15
RISC, C-24
S
safety
precautions, 5-2
electrostatic discharge, 5-3
lithium battery, 5-3
modification to equipment, 5-2
placement of a Sun product, 5-2
power cord connection, 5-3
requirements, 5-1
SBus, C-3
SBus card
extractor, removing, 10-10
removing, 10-6, 10-7
replacing, 10-8, 10-11
SBus card adapter, removing, 10-9
SC_MP, C-23
SCSI
cable
removing, 8-5
replacing, 8-7
interface, C-10
seating UPA graphics card, 10-15
securing UPA graphics card in chassis, 10-16
selected jumper settings, C-30
serial port
jumper, C-30