Service manual

Index-2 Sun Ultra 2 Series Service Manual • July 1998
terminal, C-18
connector pin assignments
fast/wide SCSI connector, B-6
keyboard connector, B-2
MII connector, B-12
mouse connector, B-2
parallel port connector, B-10
serial port A connector, B-3
serial port B connector, B-3
TPE connector, B-5
UPA graphics card connector, B-13
correct way to seat DSIMM, 10-20
CPU module
locations, 10-2
removing, 10-1, 10-3
replacing, 10-3
D
description
functional, C-1
jumper, C-29
product, 1-1
signal, B-1
SunVTS, 2-1
desktop overview, I/O devices, 1-3
diag-level flag setting, 3-2
diag-level NVRAM variable
set to max, 3-6
set to min, 3-11
diag-level switch? flag setting, 3-2
diagnostic output message
probe-scsi-all, 4-13
test, 4-14
watch-clock, 4-11
watch-net, 4-12
disabling link test, C-16
diskette drive, C-9
cable
removing, 8-8
replacing, 8-9
removing, 9-9
replacing, 9-11
document organization, xix
drive identification, internal, 4-3
DSIMM
correct way to seat, 10-20
ejection lever, 10-18
failure, 4-8
incorrect way to seat, 10-20
installation location, 10-17
physical memory addresses, 4-10
physical memory addresses (16-Mbyte
DSIMM), 4-8
physical memory addresses (32-Mbyte), 4-9
physical memory addresses (64-Mbyte), 4-9
removing, 10-17
replacing, 10-18
E
electrical specifications, A-2
electrostatic discharge, 5-3
Elite3D, installing, 10-14
enclosure
basics, C-33
features, C-33
environmental
compliance, C-34
specifications, A-3
error reporting, POST, 3-12
F
failure
DSIMM, 4-8
power-on, 4-1
fast/wide SCSI connector
pin assignments, B-6
pin configuration, B-6
signal description, B-6
FBC, C-25
FEPS, C-25
flag setting, diag-level switch?, 3-2
flash PROM
jumper, C-31
jumper settings, C-32
functional
block diagram
server, C-2
system unit, C-2
description, C-1