Service manual

Appendix C Functional Description C-17
2. At the ok prompt, type:
Note – The above screen shows the current link test state (true, or enabled),
followed by the default state (true, or enabled).
To disable the host’s link test:
1. Type the following commands:
2. Boot the host. Verify that the transceiver cable problem messages do not appear.
Type either boot net or boot disk and press Return.
C.1.11.6 Enabling the Link Test
1. If you do not see the ok prompt, press the Stop (L1) and “A” keys.
2. At the ok prompt, type:
Note – The above screen shows the current link test state (false, or disabled),
followed by the default state (true, or enabled).
3. To enable the host’s link test function, type the following commands:
ok printenv tpe-link-test?
tpe-link-test? true true
ok
ok setenv tpe-link-test? false
tpe-link-test? = false
ok reset-all
ok printenv tpe-link-test?
tpe-link-test? false true
ok
ok setenv tpe-link-test? true
tpe-link-test? = true
ok reset-all