Service manual

xii Sun Ultra 2 Series Service Manual • July 1998
FIGURE 8-3 Removing and Replacing the SCSI Cable Assembly 8-7
FIGURE 8-4 Removing and Replacing the Diskette Drive Cable Assembly 8-9
FIGURE 8-5 Shroud Assembly Removal 8-11
FIGURE 8-6 Removing and Replacing the Shroud Assembly Speaker 8-13
FIGURE 9-1 Removing and Replacing a Hard Drive 9-2
FIGURE 9-2 Removing and Replacing the Chassis Bracket 9-5
FIGURE 9-3 Removing and Replacing the CD-ROM Drive 9-8
FIGURE 9-4 Removing and Replacing the Diskette Drive 9-10
FIGURE 10-1 CPU Module Locations and Shroud Assembly Processor Area 10-2
FIGURE 10-2 Removing a CPU Module 10-3
FIGURE 10-3 NVRAM/TOD Location 10-5
FIGURE 10-4 Removing an SBus Card 10-7
FIGURE 10-5 Installing the Card Extractor 10-8
FIGURE 10-6 Removing the SBus Card Adapter Bracket 10-9
FIGURE 10-7 Removing an SBus Card Extractor 10-10
FIGURE 10-8 Replacing an SBus Card 10-11
FIGURE 10-9 Preparing to Remove a UPA Graphics Card 10-13
FIGURE 10-10 Removing a UPA Graphics Card 10-13
FIGURE 10-11 Replacing a UPA Graphics Card 10-15
FIGURE 10-12 Seating a UPA Graphics Card into the Socket 10-15
FIGURE 10-13 Securing a UPA Graphics Card into the Chassis 10-16
FIGURE 10-14 DSIMM Ejection Lever 10-18
FIGURE 10-15 Incorrect and Correct Ways to Seat the DSIMM 10-20
FIGURE 10-16 Removing a Motherboard 10-23
FIGURE 11-1 System Unit Exploded View 11-2
FIGURE B-1 Keyboard/Mouse Connector Pin Configuration B-2
FIGURE B-2 Serial Port A and B Connectors Pin Configuration B-3
FIGURE B-3 TPE Connector Pin Configuration B-5