Service manual

10-14 Sun Ultra 2 Series Service Manual • July 1996
Note – If an Elite3D UPA graphics card is being installed into a system unit that is
operating with Solaris 2.5.1 HW:11/97:
Following the installation of the Elite3D UPA graphics card software, it is
recommended that you install patch 105791-05 or later. This patch is available
through SunService.
Patch 105789-01 is applied as part of the Elite3D UPA graphics card software
installation process.
If an Elite3D UPA graphics card is being installed into a system unit that is operating
with Solaris 2.6 HW:3/98:
Following the installation of the Elite3D UPA graphics card software, it is
recommended that you install patch 105363-06 or later. This patch is available
through SunService.
1. Verify that both card retainers are pushed back (
FIGURE 10-11).
2. Remove the replacement UPA graphics card from its container.
3. At an angle, lower the UPA graphics card into the chassis over the UPA socket.
4. Hook the UPA graphics card backplate under the chassis back panel tabs.
Note – Ensure that the backplate is visible through the slot on the back panel.
Caution – Avoid applying unequal force to one end or one side of the UPA graphics
card or connector pin damage may occur.
5. Carefully press both corners of the UPA graphics card evenly to seat the UPA
graphics card connector into the UPA socket (
FIGURE 10-12).
6. Push the card retainer onto the UPA graphics card (
FIGURE 10-13).
7. Using a number 2 Phillips screwdriver, replace the two screws and washers
securing the UPA graphics card to the back panel.
8. Detach the wrist strap.
9. Replace the system unit cover.
See Section 7.3 “Replacing the System Unit Cover” on page 7-4.
10. Connect the video cable to the graphics card 13W3 video connector.