Service manual

10-12 Sun Ultra 2 Series Service Manual • July 1996
3. Remove the system unit cover.
See Section 7.1 “Removing the System Unit Cover” on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
4. Attach the wrist strap.
See Section 7.2 “Attaching the Wrist Strap” on page 7-3.
5. Unlock the card retainers (
FIGURE 10-9).
Caution – Avoid applying unequal force to one end or one side of the UPA graphics
card or connector pin damage may occur.
6. Holding the UPA graphics card at each corner, gently pull the UPA graphics card
up to disconnect it from the UPA socket (
FIGURE 10-10).
Note – Illustrations may not reflect actual UPA graphics card.
7. Slowly lift the UPA graphics card at an upward angle.
8. Lower the UPA graphics card backplate.
9. Disengage the UPA graphics card backplate from the back panel.
10. Place the UPA graphics card on an antistatic surface.