Service manual

Chapter 10 Motherboard and Component Replacement 10-11
FIGURE 10-8 Replacing an SBus Card
10.4 UPA Graphics Card (Workstation Only)
To remove and replace a UPA graphics card, proceed as follows.
10.4.1 Removing a UPA Graphics Card
1. Power off the system unit.
See Section 6.2 “Powering Off the System Unit” on page 6-2.
2. Disconnect the video cable from the graphics card 13W3 video connector.
Note: SBus slot 2 and 3 not shown
Chassis rear
SBus card 0
Card retainer
SBus card 1