Service manual

10-10 Sun Ultra 2 Series Service Manual • July 1996
FIGURE 10-7 Removing an SBus Card Extractor
6. Holding the SBus card at an angle, insert the SBus card backplate behind the tabs
at the top of the card opening (
FIGURE 10-8).
7. Lower the SBus card into position.
Caution – Do not force the SBus card or SBus slot pin damage may occur.
8. Push the SBus card into the SBus slot by carefully pressing the SBus card corners.
9. Push the card retainers forward over the edge of the SBus card.
Note – Refer to the SBus card product guide to complete any required software
installation, configuration, or setup procedures.
10. Detach the wrist strap.
11. Replace the system unit cover.
Section 7.3 “Replacing the System Unit Cover” on page 7-4.
12. Connect all cables to the SBus slots.
13. Power on the system unit.
See Section 6.1 “Powering On the System Unit” on page 6-1.
SBus card extractor
SBus card