Service manual

Chapter 10 Motherboard and Component Replacement 10-9
4. If the SBus card being installed has backplate tabs, proceed as follows
(
FIGURE 10-6):
a. Remove the screws securing the backplate adapter to the backplate.
b. Remove the backplate adapter.
c. Discard the screws and backplate adapter.
FIGURE 10-6 Removing the SBus Card Adapter Bracket
5. Remove the SBus card extractor handle as follows (FIGURE 10-7):
a. Bend one SBus card extractor handle leg slightly to the outside until the hook
clears the hole in the SBus card.
b. Remove the other side.
Note – The extractor can be removed easily without bending.
Tab
Adapter bracket