Service manual

10-8 Sun Ultra 2 Series Service Manual • July 1996
FIGURE 10-5 Installing the Card Extractor
10.3.2 Replacing an SBus Card
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
Note – Read the SBus card product guide for information about jumper or switch
settings, slot requirements, and required tools.
1. Identify the SBus slot and open the SBus card retainers.
2. As applicable, remove SBus filler panels as follows:
a. Using both hands, grasp the tabs at the base of the SBus filler panel.
b. Squeeze both tabs until the filler panel base disengages from the chassis.
c. Swing the filler panel base toward you and remove it.
3. Holding the SBus card by the edges, proceed as follows:
a. Unpack the SBus card..
b. Place the SBus card on an antistatic surface.
c. If required, set the SBus card jumpers or switches (refer to the SBus card
product guide).
Extractor