Service manual

Chapter 10 Motherboard and Component Replacement 10-7
FIGURE 10-4 Removing an SBus Card
6. Insert the extractor into the SBus card (FIGURE 10-5).
7. Holding both ends of the card extractor, pull upwards slowly until the connector
is out of the slot.
8. Remove the card extractor from the SBus card.
9. Place the SBus card on an antistatic surface.
Note: SBus slots 2 and 3 not shown
Chassis rear
SBus slot 1
SBus slot 0
Card retainer