Service manual

Chapter 9 Storage Devices 9-9
d. Connect the J5 power supply connector to the CD-ROM drive
(or 4-mm/8-mm tape drive).
e. Replace the SCSI cable assembly.
See Section 8.2.2 “Replacing the SCSI Cable Assembly” on page 8-7.
2. Replace the chassis bracket.
See Section 9.2.2 “Replacing the Chassis Bracket” on page 9-5.
3. Detach the wrist strap.
4. Replace the system unit cover.
See Section 7.3 “Replacing the System Unit Cover” on page 7-4.
5. Power on the system unit.
See Section 6.1 “Powering On the System Unit” on page 6-1.
9.4 Diskette Drive
To remove and replace the diskette drive, proceed as follows.
9.4.1 Removing a Diskette Drive
1. Power off the system unit.
See Section 6.2 “Powering Off the System Unit” on page 6-2.
2. Remove the system unit cover.
See Section 7.1 “Removing the System Unit Cover” on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 “Attaching the Wrist Strap” on page 7-3.
4. If necessary, remove the CD filler panel.
5. Remove the chassis bracket.
See Section 9.2.1 “Removing the Chassis Bracket” on page 9-4.