Service manual

9-8 Sun Ultra 2 Series Service Manual • July 1996
FIGURE 9-3 Removing and Replacing the CD-ROM Drive
9.3.2 Replacing a CD-ROM Drive or 4-mm/8-mm
Tape Drive
1. Replace the CD-ROM drive as follows (FIGURE 9-3):
a. Position the CD-ROM drive or tape drive on an antistatic surface. Align the
drive on the edge of the antistatic surface.
b. Position the chassis bracket on top of the CD-ROM drive or tape drive.
Note – If the system unit has a diskette drive, it is assembled on the chassis bracket.
c. Using a number 2 Phillips screwdriver, replace the four screws securing the
CD-ROM drive or tape drive to the chassis bracket.
SCSI cable
Chassis bracket
Screw (4)