User manual

Doc# 27-0005UM Issued 11/00 Rev 1.0
8
It is important to use the
proper screws.
To secure the StarGate
to the frame, use four
Panhead Phillips screws
and washers on each
side, for a total of eight.
NOTE: All four screw
holes in the
RETMA rail must
be visible through
the four screw
holes on both sides
of the StarGate. If
not, move the
StarGate up or
down until all
four holes are
visible.
Install StarGate
NOTE: Installing the
StarGate requires
two people, one to
hold the unit,
while the other
secures the unit
with screws.
One person hold the
right side of the
StarGate, while the
other person secures the
first screw in the upper
left corner of the unit.
Before using any
additional screws, check
to see that all the
remaining seven holes
in the StarGate line up
with the screw holes in
the RETMA rails.
Then secure the
remaining seven screws.
Do NOT tighten the
screws.
Test the fit by opening
and closing the
StarGate several times.
For a final adjustment,
make sure that the back
plate is flush against the
RETMA rail and the
back plate is square to
the RETMA rails.
Once positioned,
tighten down the screws.
Test the adjustment by
opening and closing the
StarGate display
several times.
If there is any binding,
check for alignment and
repeat the previous
step.